Non-Destructive Testing Services in Allendale, NJ

Non-Destructive Testing Services in Allendale, NJ

Allendale, NJ Ultrasonic Inspection

Uses include flaw detection/evaluation, dimensional measurements, and material characterization

Allendale, NJ API 650/ API 653

This is a worldwide recognized individual certification achieved through the American Petroleum Institute (API) testing program. Many individuals that hold this certifications are formal inspectors or welders. API 650 is the specification that deals with new construction of oil tanks. API 653 deals with the inspection, maintenance, repairs and alterations of storage tanks. This certification is highly sought after due to the volume of storage tanks located all over the United States holding petroleum products. These tanks require an external inspection every 5 years and an internal inspection every 10 years. Integrity Testlabs has performed many storage tank inspections. Radiographic inspections (RT) on the welding, Wet Fluorescent Magnetic Particle inspection on the floor plates and annular ring weld. Also Providing AUT scans, UT Thickness readings on the shell and UT crawler inspections on the outside of the tank.

Allendale, NJ API 650/ API 653

Allendale, NJ Visual Testing (VT)

Probably the most important inspection technique and one we are gifted with is visual testing with our eyes. This is a very common, low cost, quick and effective way to inspect welding, equipment, and coatings. Visual testing is the most important tool for a Certified Welding Inspector (CWI), It’s a certification you can acquire through ASNT or with your company by ASNT TC 1A. Defects commonly found using visual inspection is excessive reinforcement, underfill, undercut, porosity, cold lap. If able to access the inside or root of the weld its possible to see lack of fusion, or incomplete penetration.

Allendale, NJ Visual Testing (VT)
ASME Sec VIII; ASME Boiler & Pressure Vessel Code (BPVC)

ASME Sec VIII; ASME Boiler & Pressure Vessel Code (BPVC)

Section VIII of ASME is the code that covers the design, manufacturing, inspection and testing of pressure vessels that exceed 15 psig. This code book provides specific requirements on welding and forging, mandatory and nonmandatory appendices detailing supplementary design criteria. Manufacturing companies must be certified by AMSE. Integrity Testlabs can provide all Non-destructive need to meet or exceed the requirements of ASME Sec VIII ASTM; American Society Testing and Materials.

API 1169

API 1169

The API 1169 is a recommended practice that focuses on the basic requirements needed to do inspection on new onshore pipelines in a safe manor. Broken in to four sections. Inspector responsibilities; making sure the project moves forward in a safe and efficient manor. Inspector in responsible for planning, monitoring, evaluating, and root cause analysis. Personal and General Pipeline Safety; Making sure the requirements of OSHA 29 CFR 1910 and 29 CFR 1926 are met. Environmental and pollution control; Inspectors must know the local, state, and federal permits for Environmental and Pollution control. Basic understanding of the impacts that pipelines have on of water, land and air. General Pipeline Construction; Observing all phases of construction and understanding the difference between compliance and requirements in term on general pipeline construction.

ASME B31.3 in Allendale, NJ

ASME B31.3 in Allendale, NJ

The majority of the piping that you see when you pass an Oil Refinery, Chemical Plant, or any other typeprocessing facility is covered under ASME B31.3. Having provided Nondestructive testing services in Delaware City Refinery, Monroe Energy Refinery, Paulsboro Refinery, Advansix Chemical Plant and Chemours Chemical Plants thisspecification is the one used the most by the NDT technicians at Integrity Testlabs. The two most common acceptance criteria for AMSE B31.3 are Normal Fluid Services (NFS) and Severe Cyclic. Integrity Testlabs provides Non Destructive services of RT, UT, MT, PT, VT to cover any needs that may arise.