Blue Bell Non-Destructive Testing Services
Blue Bell Drone Inspection
Using drones is quickly becoming a common inspection method. The biggest attraction is offering a safe way to inspect confined spaces and inspected areas high in the air. With todays advanced cameras they are capable of doing a very good visual inspection. Some drones offer infrared capabilities. This allows the operator to look for hot or cold spots on equipment, structures or solar panels. Smaller drones make for good options to investigate or inspect confined spaces. Larger drones are capable of using or deploying Ultrasonics to perform thickness readings on hard to reach places. To use a drone for commercial purposes the operator must have a FAA license.
ASME Sec VIII; ASME Boiler & Pressure Vessel Code (BPVC)
Section VIII of ASME is the code that covers the design, manufacturing, inspection and testing of pressure vessels that exceed 15 psig. This code book provides specific requirements on welding and forging, mandatory and nonmandatory appendices detailing supplementary design criteria. Manufacturing companies must be certified by AMSE. Integrity Testlabs can provide all Non-destructive need to meet or exceed the requirements of ASME Sec VIII ASTM; American Society Testing and Materials.
API 570
The American Petroleum Institute (API) 570 is a in-service inspection code. Designed for the natural gas, chemical and oil refineries piping systems to prevent failures before they happen. This code covers inspection, rating, repair, and alteration procedures for applicable piping systems. This code applies to metallic and fiberglass-reinforced plastic piping systems, also pressure-relieving devices associated with the systems. Inspectors are tasked with ensuring compliance with this code is followed. Integrity Testlabs has in-house and contract API 570’s to cover any needs that fall under the API 570.
API 1169
The API 1169 is a recommended practice that focuses on the basic requirements needed to do inspection on new onshore pipelines in a safe manor. Broken in to four sections. Inspector responsibilities; making sure the project moves forward in a safe and efficient manor. Inspector in responsible for planning, monitoring, evaluating, and root cause analysis. Personal and General Pipeline Safety; Making sure the requirements of OSHA 29 CFR 1910 and 29 CFR 1926 are met. Environmental and pollution control; Inspectors must know the local, state, and federal permits for Environmental and Pollution control. Basic understanding of the impacts that pipelines have on of water, land and air. General Pipeline Construction; Observing all phases of construction and understanding the difference between compliance and requirements in term on general pipeline construction.
ASME B31.3 in Blue Bell, PA
The majority of the piping that you see when you pass an Oil Refinery, Chemical Plant, or any other typeprocessing facility is covered under ASME B31.3. Having provided Nondestructive testing services in Delaware City Refinery, Monroe Energy Refinery, Paulsboro Refinery, Advansix Chemical Plant and Chemours Chemical Plants thisspecification is the one used the most by the NDT technicians at Integrity Testlabs. The two most common acceptance criteria for AMSE B31.3 are Normal Fluid Services (NFS) and Severe Cyclic. Integrity Testlabs provides Non Destructive services of RT, UT, MT, PT, VT to cover any needs that may arise.
ASME B31.1 in Blue Bell, PA
Created in the 1930s as a standard code for power piping. ASME B31.1 is a code that provides minimum requirements for safety and guidance for the design of new piping and the repair, modifications and replacement of existing piping. Covering fuel gas and oil systems as well as central and district heating, water and steam systems. ASME B31.1 covers water and steam piping found in all power generation plants throughout the United States. Integrity Testlabs can provided technicians on your next project or outage that have vast experience and knowledge of ASME B31.1 acceptance criteria.
