Keasbey Non-Destructive Testing Services
ANST Level I and Assistants
Becoming certified or learning about Nondestructive testing can be achieved in two ways. Enrolling in a school that provides a certificate or degree or getting hired on with a company with no knowledge of the industry and learning on the job. Typically 40hrs of radiation safety is the first step/certificate that is needed to get started. Once the Assistant has had some time in the industry the company will provide them with classroom training either in house, computer based or sending them to a course provided by a known 3rd party. When the Assistants meets the required OJT hours and classroom time. They will test with the company they are with by completing a specific, general and practical exams. When this is completed, they are now a Level II technician.
Keasbey, NJ Visual Testing (VT)
Probably the most important inspection technique and one we are gifted with is visual testing with our eyes. This is a very common, low cost, quick and effective way to inspect welding, equipment, and coatings. Visual testing is the most important tool for a Certified Welding Inspector (CWI), It’s a certification you can acquire through ASNT or with your company by ASNT TC 1A. Defects commonly found using visual inspection is excessive reinforcement, underfill, undercut, porosity, cold lap. If able to access the inside or root of the weld its possible to see lack of fusion, or incomplete penetration.
Eddy Current
Eddy Current uses electromagnetic induction with alternating currents passed through a coil. The coil produces alternating magnetic field. Used extensively in the aircraft industry and manufacturing industry to look for surface and subsurface defects. Also used in the Nuclear and Petro chemical industry on heat exchanger tubing. When the surface is properly cleaned Eddy Current (ET) can be a fast and very effective Nondestructive inspection.
Keasbey Drone Inspection
Using drones is quickly becoming a common inspection method. The biggest attraction is offering a safe way to inspect confined spaces and inspected areas high in the air. With todays advanced cameras they are capable of doing a very good visual inspection. Some drones offer infrared capabilities. This allows the operator to look for hot or cold spots on equipment, structures or solar panels. Smaller drones make for good options to investigate or inspect confined spaces. Larger drones are capable of using or deploying Ultrasonics to perform thickness readings on hard to reach places. To use a drone for commercial purposes the operator must have a FAA license.
ACFM; Alternating current field measurement in Keasbey, NJ
Integrity Testlabs was one of the first companies to provide this inspection technique in the Northeast. ITL technicians have completed hundreds ACFM inspections on equipment shells in oil refineries in the Northeast. ACFM is a electromagnetic technique used for detecting cracks breaking the surface. Capable of also sizing the defect. ACFM can be used on ferrous and nonferrous metals. ACFM can be fast and effective inspection. It does need the area to be cleaned and electric available to run the ACFM unit. Wet Fluorescent Magnetic Testing (WFMT) can be used as an alternate inspection to confirm the findings of the ACFM.
ASNT; American Society for Nondestructive testing
A nonprofit organization which is governed by a board of directors. ASNT publishes and maintains SNT-TC-1A, Standards, Codes of practice, ANSI/ASNT CP-189 and CP-105. They also cover all aspects of qualification and certification of NDT personnel. Integrity Testlabs has a ANST Level III on staff that certifies our Level II and Level I employees so they meet the SNT-TC-1A requirements.
