Palermo Non-Destructive Testing Services

Palermo Non-Destructive Testing Services

Ground Penetrating Radar in Palermo, NJ

Integrity Testlabs can provide a safe, cost effective and nondestructive means to scan concrete slabs or structures prior to drilling, cutting or coring. Prior to doing destructive work to concrete, inspecting the interior for possible post tension cables, electrical lines, pipes and rebar can save you time and money. ITL trained technicians that can provide this service and mark out where these items exist inside the concrete. This risk mitigation technique will allow you to cut, core or drill with a peace of mind.

Ground Penetrating Radar in Palermo, NJ

Palermo, NJ Visual Testing (VT)

Probably the most important inspection technique and one we are gifted with is visual testing with our eyes. This is a very common, low cost, quick and effective way to inspect welding, equipment, and coatings. Visual testing is the most important tool for a Certified Welding Inspector (CWI), It’s a certification you can acquire through ASNT or with your company by ASNT TC 1A. Defects commonly found using visual inspection is excessive reinforcement, underfill, undercut, porosity, cold lap. If able to access the inside or root of the weld its possible to see lack of fusion, or incomplete penetration.

Palermo, NJ Visual Testing (VT)

ASNT; American Society for Nondestructive testing

A nonprofit organization which is governed by a board of directors. ASNT publishes and maintains SNT-TC-1A, Standards, Codes of practice, ANSI/ASNT CP-189 and CP-105. They also cover all aspects of qualification and certification of NDT personnel. Integrity Testlabs has a ANST Level III on staff that certifies our Level II and Level I employees so they meet the SNT-TC-1A requirements.

ASNT; American Society for Nondestructive testing

Palermo, NJ Ultrasonic Inspection

Uses include flaw detection/evaluation, dimensional measurements, and material characterization

ASME B31.1 in Palermo, NJ

Created in the 1930s as a standard code for power piping. ASME B31.1 is a code that provides minimum requirements for safety and guidance for the design of new piping and the repair, modifications and replacement of existing piping. Covering fuel gas and oil systems as well as central and district heating, water and steam systems. ASME B31.1 covers water and steam piping found in all power generation plants throughout the United States. Integrity Testlabs can provided technicians on your next project or outage that have vast experience and knowledge of ASME B31.1 acceptance criteria.

ASME B31.1 in Palermo, NJ
API 570

API 570

The American Petroleum Institute (API) 570 is a in-service inspection code. Designed for the natural gas, chemical and oil refineries piping systems to prevent failures before they happen. This code covers inspection, rating, repair, and alteration procedures for applicable piping systems. This code applies to metallic and fiberglass-reinforced plastic piping systems, also pressure-relieving devices associated with the systems. Inspectors are tasked with ensuring compliance with this code is followed. Integrity Testlabs has in-house and contract API 570’s to cover any needs that fall under the API 570.