South Dayton Non-Destructive Testing Services

South Dayton Non-Destructive Testing Services

ANST Level I and Assistants

ANST Level I and Assistants

Becoming certified or learning about Nondestructive testing can be achieved in two ways. Enrolling in a school that provides a certificate or degree or getting hired on with a company with no knowledge of the industry and learning on the job. Typically 40hrs of radiation safety is the first step/certificate that is needed to get started. Once the Assistant has had some time in the industry the company will provide them with classroom training either in house, computer based or sending them to a course provided by a known 3rd party. When the Assistants meets the required OJT hours and classroom time. They will test with the company they are with by completing a specific, general and practical exams. When this is completed, they are now a Level II technician.

ASME Sec VIII; ASME Boiler & Pressure Vessel Code (BPVC)

ASME Sec VIII; ASME Boiler & Pressure Vessel Code (BPVC)

Section VIII of ASME is the code that covers the design, manufacturing, inspection and testing of pressure vessels that exceed 15 psig. This code book provides specific requirements on welding and forging, mandatory and nonmandatory appendices detailing supplementary design criteria. Manufacturing companies must be certified by AMSE. Integrity Testlabs can provide all Non-destructive need to meet or exceed the requirements of ASME Sec VIII ASTM; American Society Testing and Materials.

ASME B31.1 in South Dayton, NY

Created in the 1930s as a standard code for power piping. ASME B31.1 is a code that provides minimum requirements for safety and guidance for the design of new piping and the repair, modifications and replacement of existing piping. Covering fuel gas and oil systems as well as central and district heating, water and steam systems. ASME B31.1 covers water and steam piping found in all power generation plants throughout the United States. Integrity Testlabs can provided technicians on your next project or outage that have vast experience and knowledge of ASME B31.1 acceptance criteria.

ASME B31.1 in South Dayton, NY
ASME B31.3 in South Dayton, NY

ASME B31.3 in South Dayton, NY

The majority of the piping that you see when you pass an Oil Refinery, Chemical Plant, or any other typeprocessing facility is covered under ASME B31.3. Having provided Nondestructive testing services in Delaware City Refinery, Monroe Energy Refinery, Paulsboro Refinery, Advansix Chemical Plant and Chemours Chemical Plants thisspecification is the one used the most by the NDT technicians at Integrity Testlabs. The two most common acceptance criteria for AMSE B31.3 are Normal Fluid Services (NFS) and Severe Cyclic. Integrity Testlabs provides Non Destructive services of RT, UT, MT, PT, VT to cover any needs that may arise.

South Dayton, NY Visual Testing (VT)

Probably the most important inspection technique and one we are gifted with is visual testing with our eyes. This is a very common, low cost, quick and effective way to inspect welding, equipment, and coatings. Visual testing is the most important tool for a Certified Welding Inspector (CWI), It’s a certification you can acquire through ASNT or with your company by ASNT TC 1A. Defects commonly found using visual inspection is excessive reinforcement, underfill, undercut, porosity, cold lap. If able to access the inside or root of the weld its possible to see lack of fusion, or incomplete penetration.

South Dayton, NY Visual Testing (VT)

South Dayton, NY Non-Destructive Visual Testing (VT)